Cnc3 3018 pro manual4/6/2024 ![]() This depends on the mechanics of the limit switches, but seems OK with the MBI-style switches I used: $27=1.000 sets the Pull-off distance from all three Home positions, so the machine ends up at absolute XYZ = -1.000 mm relative to the switch trip points after homing. $22=1 enables the Home cycle, after which you must start each session by homing the machine. $21=0 leaves Hard Limits off, because I didn’t see much point in switches on both ends of all the axes for this little bitty machine. $20=1 turns on Soft Limits, thereby producing an error when you (or the G-Code) tries to move beyond the machine’s limits, as defined by the $120 $121 $122 values relative to the Home switch positions. $3=5 reverses the X and Z motor rotation, so you can use the same type of cable on all three axes and have them move the way you’d expect. There’s no force worth mentioning on a diamond scribe when the motors stop, so there’s no reason to keep them energized, and the DRV8825 chips resume from the same microstep when re-enabled. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |